If the spray cannot be sprayed, it is recommended to check whether the small hole at the nozzle is blocked, dredge the small hole, or remove the nozzle and soak it in hot water for five minutes before installing the nozzle.
The principle of spray is to pressurize the bottle, and the liquid is sprayed out in the high-pressure system with very fine water particles. When the spray cannot be sprayed out, it is recommended to follow the following steps:
1. First check the nozzle to see if it is blocked by foreign matters. If it is blocked, use toothpicks or needles to unblock the nozzle. Always cover the spray after use to prevent dust from adhering to the nozzle.
2. Check the nozzle to see if it has sunk. If the pressure on the nozzle is too strong, the nozzle may not automatically recover to its original position after use. Pull the nozzle up to the same height as the original one. The nozzle can be used again after recovery.
3. If the internal part of the nozzle is blocked, the nozzle can be removed, soaked in hot water for about 5 minutes, and then installed to resume normal use.
