Lotion pump head is a common type of bottle cap, which is used to provide a convenient way to use lotion bottles. If you also want to know how to correctly assemble the lotion pump head, the following article will explain it in detail.
Firstly, it is necessary to ensure that the caliber of the pump head and bottle body are the same, otherwise it cannot be assembled. Next, you need to disassemble the pump head and take out all the parts for separate inspection.
The first step is to insert the pipe into the bottom of the pump head, taking care not to tilt or deform.
Step 2, lift the piston and install it at the end of the pipe. At the same time, gently press with your fingers to allow the piston to move smoothly.
The third step is to inject lotion into the pipe. Please note that the amount of lotion injected should not exceed two-thirds of the pipe capacity, otherwise the pump head will be blocked.
Step 4: Screw the open cover back into its original position and confirm that the pump head has been fully assembled.
Finally, we need to note that when installing the pump head onto the bottle, it is necessary to first rotate the pump head so that the plastic wire on it appears directly below the bottle mouth. This way, the pump head can be easily twisted into the bottle body, while also ensuring a tight connection between the pump head and the bottle body.
It is not difficult to assemble the lotion pump head. It can be successfully completed by paying attention to every step and detail carefully.